{"id":4832,"date":"2020-10-19T13:20:00","date_gmt":"2020-10-19T13:20:00","guid":{"rendered":"https:\/\/www.waters.com\/blog\/the-evolving-regulations-guiding-nitrosamines\/"},"modified":"2022-07-28T03:15:42","modified_gmt":"2022-07-28T03:15:42","slug":"the-evolving-regulations-guiding-nitrosamines","status":"publish","type":"post","link":"https:\/\/www.waters.com\/blog\/the-evolving-regulations-guiding-nitrosamines\/","title":{"rendered":"The Evolving Regulations Guiding Nitrosamines"},"content":{"rendered":"

In July 2018, the European Medicines Agency (EMA) reported the recall of a number of products containing the active pharmaceutical ingredient (API) valsartan due to contamination with a known carcinogen, dimethyl nitrosamine, also referred to as N-nitroso dimethylamine (NDMA).\u00a0 This action set off a chain of events that led to similar notifications of recalls for several sartan products across multiple regional authorities.\u00a0 Moreover, the announcement of the discovery of NDMA was quickly followed by reports of the detection of another N-Nitrosamine \u2013 N-Nitroso diethylamine (NDEA).<\/p>\n

These events understandably triggered many authorities, including the European Commission (EC), to launch formal investigations aimed at identifying the root causes of the contamination.\u00a0 The EC initiated a procedure on 5\u00a0July 2018, pursuant to Article 31 of Directive 2001\/83\/EC., outlining the expectations for control and, where possible, avoidance of N Nitrosamines in sartans. Since then, reports of further concerns relating to other N-Nitrosamines have continued, as summarized below.<\/p>\n

\"\"
Timeline of N-Nitrosamine reporting<\/figcaption><\/figure>\n

The initial Article 31 process was specific to the class of drugs referred to as \u201csartans\u201d, but even within this single class there is a complex process to establish safety limits for each sartan based product. The principles defined within ICH M7 are dependent on the relative safety data of each N-Nitrosamine contaminant and the daily dose of each sartan, which can range from 32mg\/day to 320mg\/day.<\/p>\n

\"\"
N-Nitrosamine limits of detection (LOD) in sartan drug substances<\/figcaption><\/figure>\n

Somewhat controversially, these were defined as interim limits applicable for a 2-year period, after which a single blanket limit of 0.03ppm was established for any N-Nitrosamine in any Sartan. \u00a0This represents a significant shift away from scientific, safety-based limits, toward an \u201cas low as reasonably practical\u201d approach (ALARP), making N-Nitrosamines a \u2018special case\u2019.<\/p>\n

At the same time, a similar action was taken by other regulatory authorities including Swiss Medic, Health Canada, and a plethora of others.\u00a0 The United States FDA took a somewhat different approach requesting that detection of any N-Nitrosamine at any level be reported.\u00a0 The FDA revealed further its thinking in a general advice letter sent to individual marketing authorization holders through a series of specific requirements:<\/p>\n

    \n
  • Batch testing to verify no detectable nitrosamine in the API<\/u> should continue unless the API producer has demonstrated their process is not at risk for producing detectable nitrosamines in accordance with guidance (for example, ICH Q7).<\/li>\n<\/ul>\n

    This includes demonstrating that:<\/p>\n

      \n
    • starting materials, including vendor-supplied intermediates, have no detectable nitrosamines or such low amounts can be purged ensuring that the API contains no detectable amounts of nitrosamines, and<\/li>\n
    • raw materials used in the process, including recovered solvents and catalysts, contain no detectable amounts nitrosamines.<\/li>\n<\/ul>\n

      By also focusing on starting materials, solvents, and catalysts used in the process, the scope of investigations was significantly extended.\u00a0 This was, in many ways, a portent of what followed.<\/p>\n

      In September 2019 the situation relating to N-Nitrosamines changed dramatically.\u00a0 Reports from the EMA, FDA, and the wider public press, including the New York Times, reported the detection of NDMA \u00a0in ranitidine, stating that due to its unique structure, it could degrade to generate NDMA from the molecule itself.<\/p>\n

      \"\"<\/p>\n

      Perhaps as a consequence, this triggered the EMA to introduce a second, far more wider ranging process, Article 5(3) – Information on nitrosamines for marketing authorization holders, which required evaluation of the risk of nitrosamine impurities in any<\/u> human medicinal products containing chemically synthesised active pharmaceutical ingredients.<\/p>\n

      This widened the investigation from Sartans to all synthetic molecules, with an initially extremely tight deadline of 6 months, although this was later extended until October 1st<\/sup> 2020 and then extended again to March 2021.\u00a0 Accompanied by a Q&A document, the Article 5(3) set out the following requirements:<\/p>\n

      Evaluate the possibility of the presence of nitrosamines in every medicine within 6 months:<\/p>\n

        \n
      • Prioritize evaluations, starting with medicines more likely to contain nitrosamines<\/li>\n
      • Take into account findings from CHMP\u2019s review of sartans<\/li>\n
      • Notify authorities of outcome of risk evaluations<\/li>\n
      • Test products at risk of containing any nitrosamines<\/li>\n
      • Immediately report detection of nitrosamines to authorities<\/li>\n
      • Apply for necessary changes to marketing authorizations to address nitrosamine risk<\/li>\n
      • Complete all steps within 3 years, prioritizing high risk products<\/li>\n<\/ul>\n

        The evaluation is split into 2 steps<\/p>\n

        Step 1 – Risk evaluation: Marketing Authorization Holders (MAH) should perform risk evaluation of their medicinal products containing the chemically synthesised API. MAHs were asked to prioritize products in order to establish the sequence in which their products are to be evaluated, based on the principles defined within ICH M7 and ICH Q9.<\/p>\n

        MAHs should inform the concerned Competent Authorities when the risk evaluation is concluded. If a risk of presence of nitrosamines is identified as a result of the evaluation, the MAH should proceed to Step 2.<\/p>\n

        Step 2-Confirmatory testing: If the evaluation conducted in Step 1 identified a risk of the presence of nitrosamines, confirmatory testing should be carried out. Any needed changes to the manufacturing process that are indicated should be concluded within 3 years of the publication of the notification.<\/p>\n

        MAHs should inform the relevant authorities immediately if tests confirm the presence of a nitrosamine impurity, irrespective of the amount detected.\u00a0 Crucially, no specific limits are mentioned.<\/p>\n

        At the same time, Health Canada, Swiss Medic and other agencies issued similar, but not identical requests, compounding the complexity of responding to each agency.\u00a0 Although welcome, the announcement in March of postponement of the EMA Article 5(3) brought further challenges as not all other authorities immediately modified their timelines.<\/p>\n

        In a further twist in July 2020, the EMA issued their finalized Article 5(3) report, soon afterwards also revising their associated Questions and Answers document, for the third time.\u00a0 Significant within this were the following changes:<\/p>\n

        \"\"<\/p>\n

        \"\"<\/p>\n

        The concern is that this generic limit of 18 ng\/day, when combined with a method requirement of 10% of the allowable intake (AI) for testing drug product, will render the analysis of some drug products as technically unfeasible. Will regulatory authorities continue to chase lower specifications as analytical methods leveraging high performance specialty instruments make lower detection limits possible? Will this be the end of regulatory changes? At this stage, it is impossible to say but cannot be ruled out. Such concerns will be examined further in the final blog of this series.<\/p>\n","protected":false},"excerpt":{"rendered":"

        In July 2018, the European Medicines Agency (EMA) reported the recall of a number of products containing the active pharmaceutical ingredient (API) valsartan due to contamination with a known carcinogen, dimethyl nitrosamine, also referred to as N-nitroso dimethylamine (NDMA).\u00a0 This action set off a chain of events that led to similar notifications of recalls for…<\/p>\n","protected":false},"author":123,"featured_media":2822,"comment_status":"open","ping_status":"open","sticky":false,"template":"","format":"standard","meta":{"_acf_changed":false,"_seopress_titles_title":"","_seopress_titles_desc":"","_seopress_robots_index":"","_seopress_robots_follow":"","_seopress_robots_imageindex":"","_seopress_robots_snippet":"","_seopress_robots_primary_cat":"","_seopress_robots_breadcrumbs":"","_seopress_robots_freeze_modified_date":"","_seopress_robots_custom_modified_date":"","_seopress_robots_canonical":"","_seopress_social_fb_title":"","_seopress_social_fb_desc":"","_seopress_social_fb_img":"","_seopress_social_fb_img_attachment_id":0,"_seopress_social_fb_img_width":0,"_seopress_social_fb_img_height":0,"_seopress_social_twitter_title":"","_seopress_social_twitter_desc":"","_seopress_social_twitter_img":"","_seopress_social_twitter_img_attachment_id":0,"_seopress_social_twitter_img_width":0,"_seopress_social_twitter_img_height":0,"_seopress_redirections_value":"","_seopress_redirections_enabled":"","_seopress_redirections_enabled_regex":"","_seopress_redirections_logged_status":"","_seopress_redirections_param":"","_seopress_redirections_type":0,"_seopress_analysis_target_kw":"","_seopress_news_disabled":"","_seopress_video_disabled":"","_seopress_video":[],"_seopress_pro_schemas_manual":[],"_seopress_pro_rich_snippets_disable_all":"","_seopress_pro_rich_snippets_disable":[],"_seopress_pro_schemas":[],"_kad_blocks_custom_css":"","_kad_blocks_head_custom_js":"","_kad_blocks_body_custom_js":"","_kad_blocks_footer_custom_js":"","_kad_post_transparent":"","_kad_post_title":"","_kad_post_layout":"","_kad_post_sidebar_id":"","_kad_post_content_style":"","_kad_post_vertical_padding":"","_kad_post_feature":"","_kad_post_feature_position":"","_kad_post_header":false,"_kad_post_footer":false,"_kad_post_classname":"","footnotes":""},"categories":[25],"tags":[346],"class_list":["post-4832","post","type-post","status-publish","format-standard","has-post-thumbnail","hentry","category-pharmaceutical","tag-nitrosamine"],"acf":[],"taxonomy_info":{"category":[{"value":25,"label":"Pharmaceutical"}],"post_tag":[{"value":346,"label":"Nitrosamine"}]},"featured_image_src_large":["https:\/\/www.waters.com\/blog\/wp-content\/uploads\/lh1-1024x326.png",1024,326,true],"author_info":{"display_name":"Andy Teasdale","author_link":"https:\/\/www.waters.com\/blog\/author\/ateasdale\/"},"comment_info":"","category_info":[{"term_id":25,"name":"Pharmaceutical","slug":"pharmaceutical","term_group":0,"term_taxonomy_id":25,"taxonomy":"category","description":"We bring high-value technologies designed to solve critical, analytical problems. We enable profound discoveries, optimize lab operations and ensure regulatory compliance. We help customers turn global industry challenges into the medicines that offer hope.","parent":0,"count":101,"filter":"raw","term_order":"0","cat_ID":25,"category_count":101,"category_description":"We bring high-value technologies designed to solve critical, analytical problems. We enable profound discoveries, optimize lab operations and ensure regulatory compliance. We help customers turn global industry challenges into the medicines that offer hope.","cat_name":"Pharmaceutical","category_nicename":"pharmaceutical","category_parent":0}],"tag_info":[{"term_id":346,"name":"Nitrosamine","slug":"nitrosamine","term_group":0,"term_taxonomy_id":346,"taxonomy":"post_tag","description":"","parent":0,"count":4,"filter":"raw","term_order":"0"}],"_links":{"self":[{"href":"https:\/\/www.waters.com\/blog\/wp-json\/wp\/v2\/posts\/4832","targetHints":{"allow":["GET"]}}],"collection":[{"href":"https:\/\/www.waters.com\/blog\/wp-json\/wp\/v2\/posts"}],"about":[{"href":"https:\/\/www.waters.com\/blog\/wp-json\/wp\/v2\/types\/post"}],"author":[{"embeddable":true,"href":"https:\/\/www.waters.com\/blog\/wp-json\/wp\/v2\/users\/123"}],"replies":[{"embeddable":true,"href":"https:\/\/www.waters.com\/blog\/wp-json\/wp\/v2\/comments?post=4832"}],"version-history":[{"count":0,"href":"https:\/\/www.waters.com\/blog\/wp-json\/wp\/v2\/posts\/4832\/revisions"}],"wp:featuredmedia":[{"embeddable":true,"href":"https:\/\/www.waters.com\/blog\/wp-json\/wp\/v2\/media\/2822"}],"wp:attachment":[{"href":"https:\/\/www.waters.com\/blog\/wp-json\/wp\/v2\/media?parent=4832"}],"wp:term":[{"taxonomy":"category","embeddable":true,"href":"https:\/\/www.waters.com\/blog\/wp-json\/wp\/v2\/categories?post=4832"},{"taxonomy":"post_tag","embeddable":true,"href":"https:\/\/www.waters.com\/blog\/wp-json\/wp\/v2\/tags?post=4832"}],"curies":[{"name":"wp","href":"https:\/\/api.w.org\/{rel}","templated":true}]}}